Posted: Thu May 08, 2003 7:39 pm
Bleed screw is upper right it is the on with copper washer on.I used .032 thick aluminum I also made a washer out of the same material and added it to the washer on impellar shaft so clearance stayed same.I trimmed the tabs off of the xring that stuck out.
I used black silicone light coating all over back of plate and a fine bead arond seal and passage.
According to the maps the cooling fan comes on at 176 deg.F turns off at 159 deg.F.
There is also a safety feature.At 202 deg.F safety measures are in effect.At 231 deg.F I think the motor will shut off.I have never seen either of the safety features work but they are there.
I used black silicone light coating all over back of plate and a fine bead arond seal and passage.
According to the maps the cooling fan comes on at 176 deg.F turns off at 159 deg.F.
There is also a safety feature.At 202 deg.F safety measures are in effect.At 231 deg.F I think the motor will shut off.I have never seen either of the safety features work but they are there.