Anyone ever drag raced their Dale??

Message

thomez · #21 Post by **thomez** » Tue Mar 23, 2004 9:18 pm

Good RWHP numbers

What AFR were you shooting for? I would think you would have been able to get it dialed in with the tool... kinda stinks if you can't. I don't know what you would do to keep it from running lean then?

J. Delaney · #22 Post by **J. Delaney** » Wed Mar 24, 2004 3:56 am

Are you sure the fuel filter is not plugged up? And what about the fuel pump? Is it putting out adequate pressure?

cannibalq8 · #23 Post by **cannibalq8** » Wed Mar 24, 2004 5:46 am

GOOD RESULTS Dude

.. 42 H.P with stock exhaust is excellent result .. with 79 MPH that's very nice also

. its rare to see stock dale with that results in both H.P's and MPH
... r u at sea level ?

so what is ur next step Dragracr ....ECU sagem 1000 , pipe , port the head,new 5th gear set or re-angle the injectors ?

do u try to re-gear it ? maybe u can get better timing by buying cheap sprockets ?

NRath · #24 Post by **NRath** » Wed Mar 24, 2004 5:44 pm

Isn't there a screw on the MC500 ecu's that'll richen/lean it as you turn it?

Derno24 · #25 Post by **Derno24** » Wed Mar 24, 2004 6:08 pm

All ecu adjustments are done through the MIL tool. I didn't think there was another way to adjust it. I may be wrong. If you want the authority on this call Kyle at R&S hard to get ahold of, but will definitely know this answer better than anyone.

Ryanstones · #26 Post by **Ryanstones** » Wed Mar 24, 2004 6:15 pm

QUOTE

Originally posted by NRath
Isn't there a screw on the MC500 ecu's that'll richen/lean it as you turn it?

That's right, at the front of 500ECU there is an inset plastic screw that will richen/lean the mix across the entire rev range.
Take a look at that Dragrcr. right is richer, left, leaner. In my limited experience, a little turn goes a long way. I guess i was thinking you had used that already.

Derno24 · #27 Post by **Derno24** » Wed Mar 24, 2004 6:25 pm

Or RYan would know the answer too.

Proceeding to remove foot from mouth. Scalple, Check, Hammer, Check.......

Ryanstones · #28 Post by **Ryanstones** » Wed Mar 24, 2004 7:59 pm

we all know you are just tryin to help. LOL.

cannibalq8 · #29 Post by **cannibalq8** » Thu Mar 25, 2004 8:05 am

right Derno24

call Kyle from reperformance at 812-279-5833 . i remeber he can update ur sagem from 500 to sagem1000. that's will be cheaper... i belive Maz from www.cdalparts.com, http://www.sprocketspecialists.com/html/ca...annondale.shtml and i guess www.rockymountainatv.com have sprockets

Cannondaleriders

Anyone ever drag raced their Dale??

put away the tools Derno