Page 10 of 10
Posted: Fri Mar 13, 2009 4:19 am
by quadsourcemark
Yes I measured them all. I used my Blackberry for the photos. My camera is MIA!
Thanks,
Mark
Ok its running again. I replaced the whole decomp assembly. I have pics of the old assembly. You'll notice in the pictures the gap between the backing plate and counter weight. Was this the Problem? I can only assume since it showed 70psi of compression on the bench after I changed it. Almost 30psi with the old assembly. It fired right up in the chassis.
I want to thank everyone for there help
Mark
Posted: Fri Mar 13, 2009 12:00 pm
by cannondale27
That decomp is very shot.Wore and in this pic it looks like the pin in the barrel is either really bent or installed backwards in barrel.The barrel which contacts bucket is not in right position-vs-the wieght.Congratulations!
[attachment=8202:post_207...59_thumb.jpg]
Posted: Fri Mar 13, 2009 9:59 pm
by quadsourcemark
[quote name='cannondale27' date='Mar 13 2009, 12:00 PM' post='203877']
That decomp is very shot.Wore and in this pic it looks like the pin in the barrel is either really bent or installed backwards in barrel.The barrel which contacts bucket is not in right position-vs-the wieght.Congratulations!
[attachment=8202:post_207...59_thumb.jpg]
That pic is the new decomp assembly. The first three pics are the old decomp assembly. The pics are fuzzy but it's assembled correctly. It starts normal and has loads of power! I ran it today for a half hour. No issues so far.
Thanks again,
Mark
Posted: Sat Mar 14, 2009 5:06 am
by cannondale27
Cool.Must just be the angle of the pic.