Page 1 of 1
Clamp On Filter
Posted: Tue Apr 26, 2005 1:41 am
by MrSlithers
I would really like to clean up the look of my Dale so I was wanting to remount my fuel pump and battery and get rid of the airbox and ECU tray with the filter so I was thinkin about getting a clamp on foam air filter. But before I do, what all do I need to know and do? And, what size filter (diameter) should I be lookin for?
Posted: Tue Apr 26, 2005 4:10 am
by superfly
I just switched from k&n clamp on to UNI clamp on, they were both universals and the same size, 2 1/4 flange, angle 20 degrees, and 6 in tall. Dual stage UNI is nice in wetter muddier conditions.
Posted: Tue Apr 26, 2005 4:14 am
by claas900
..does that one fit under the stock tank/air box cover?.Were did you get it at? Or do you have a part # maybe?
Posted: Tue Apr 26, 2005 11:42 pm
by MrSlithers
Where do I put the air box pressure sensor at once the airbox is gone?
Posted: Wed Apr 27, 2005 12:36 pm
by haydug
Contact canniboomer, I know Dave has a kit (or I think so anyway LOL) that is a bolt on deal. He also has foam or K&N filters. I personally do not like a K&N, but Kenny (my mechanic aka: housercannondale) has a clamp on K&N and loves it.
Posted: Wed Apr 27, 2005 5:27 pm
by MrSlithers
I'd still beable to leave the ECU tray in its place right? Im gonna go up town here later and get a foam UNI but if I don't have any luck, I will get a hold of boomer.
Posted: Sat Apr 04, 2009 1:39 am
by Trouble
just clamp the sensor out of the way.get any universal filter with a 52mm or so flange.This may not be the best set up for wet conditions but works well for me.Plus it only costs me a few bucks for the filter.i know old post but some people still own dales..lol