Engine, intake, exhaust, EFI, chain, sprockets, etc.
cdalemx301
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#1
Post
by cdalemx301 » Sun Jul 03, 2005 3:54 am
So I put 18s on my Cannibal...Bumped up to a 14T front and still have the stock rear on is it a 42t? What is recomended for rear size should i run a 40 or keep it at 42? Also what size chain will i need with a sprocket change
CDMX215
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#2
Post
by CDMX215 » Mon Jul 04, 2005 2:02 pm
mike i run 14/39 for most. 14 /42 would be for like supercross lots of bottom not top end like you described in your other thread try to think like ten speed is how i do it little front big back pedal like **** go no where fast big front little back pedal long strokes go like ****
haydug
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#3
Post
by haydug » Mon Jul 04, 2005 2:06 pm
I run 14/38 on my bikes and sometimes will switch to a 40 for a small/tight track.
cdalemx301
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#4
Post
by cdalemx301 » Mon Jul 04, 2005 2:24 pm
John and doug you are both runnin big motors right? will a stock motor be able to run a 39 rear?
theJeStEr1340
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#5
Post
by theJeStEr1340 » Mon Jul 04, 2005 2:44 pm
I was running a stock motor and was runing 14/38, but will probably go with 15/38 with the 450.
cannondalerhino
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#6
Post
by cannondalerhino » Mon Jul 04, 2005 4:07 pm
I run a 13/39, with the timbo stroker and it throws my big *** around the mx track just fine. pulls the 40 good too.
cdalemx301
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#7
Post
by cdalemx301 » Mon Jul 04, 2005 4:23 pm
what size chain will i need with 14 39
cdalemx301
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#9
Post
by cdalemx301 » Mon Jul 04, 2005 8:22 pm
What size is stock? I need a new one
CDMX215
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#10
Post
by CDMX215 » Tue Jul 05, 2005 1:30 am
mike if i remember right i believe its 92 links i usaully order 100 links and cut to fit