I need help fast!

Message

Rookiex · #1 Post by **Rookiex** » Wed Mar 26, 2003 5:07 pm

What are the tourqe specs on the stud up dates for each place they should go.....Someone please help I don't have a manual or anything yet K&K are still sendin it an we are in the motor now....Cdale27 I know you worked on your alot I know you could help me out!

atvrulz · #2 Post by **atvrulz** » Wed Mar 26, 2003 5:37 pm

I have the stud update kit from quadsource motorsports.
It comes with 8 studs with hexagon nuts and a rubber fitting called a gasket that the side casing rests up against when you close the side casing. On my instructions, it says to put studs into engine so that 18 mm is sticking out. tighting all eight nuts to 24 lb ft (32 Nm). it also says to use red loctite on all studs and bolts.

DangerRanger · #3 Post by **DangerRanger** » Thu Mar 27, 2003 8:15 am

You do not torque the studs. Simply install them to the 18m height with loctite and let cure for 72 hours. Then install the nuts and torque them to 24ftlbs.

Ben