Idle at 8.1%?

Message

Jctmotorsports · #1 Post by **Jctmotorsports** » Thu Oct 20, 2005 4:56 am

To get my moto to idle the throttle is at 8.1% at 2100rpms. I hear you guys at 4-6 % When I do a throttle cal it's at 3% with no throttle screw, at .31 volts. It runs good up the ladderbut would like to fix this off idle lag- occasional stall.
Chuck

saltus440 · #2 Post by **saltus440** » Thu Oct 20, 2005 8:51 am

hmmm

I idle @ 8% @2200 rpm's. I saw reports of others at 4% but did not know what to think. Maybe we both have bad TPS's or IACV problems????? My bike runs ok though but I never rode another dale so I have no comparison.

cannondale27 · #3 Post by **cannondale27** » Thu Oct 20, 2005 11:23 am

Try leaning out the offset to get rid of lowend hesitation and it should lower the %.

c41xracer · #4 Post by **c41xracer** » Thu Oct 20, 2005 11:53 am

mines at 6.1%

cannondale27 · #5 Post by **cannondale27** » Thu Oct 20, 2005 12:02 pm

QUOTE

When I do a throttle cal it's at 3% with no throttle screw

This is odd.Is your cable loose when you do this?Use your finger to push throttle closed.

Jctmotorsports · #6 Post by **Jctmotorsports** » Thu Oct 20, 2005 2:54 pm

Lean which offset inj or tb? Yes the plate is closed, I had the airbox off because I thought I had an intake leak. Throttle plate 100% closed at .31 volts shows 3% throttle. When I add 3 it goes to 6 and I have to take it up to right at 8 as the iacv closes completely.
Chuck

cannondale27 · #7 Post by **cannondale27** » Thu Oct 20, 2005 5:01 pm

I dont think that will work for him since he is starting out at 3.Normally they start out around 1.

Derno24 · #8 Post by **Derno24** » Thu Oct 20, 2005 5:15 pm

As you change the flowrate or the Throttle body leakage it will affect the percentages.

cannondale27 · #9 Post by **cannondale27** » Thu Oct 20, 2005 5:21 pm

I agree always runs best when at around 3.5% but it is wierd that he is there already with idle screw backed all the way off.What % do you guys get when idle screw is backed all the way off?

cannondale27 · #10 Post by **cannondale27** » Thu Oct 20, 2005 5:30 pm

Alright then I guess its not a issue and he just needs to get his offset right.