Which chain?

Message

jesshamner · #1 Post by **jesshamner** » Wed Mar 01, 2006 6:13 pm

I need a new one. I just wanted to see what you guys/girls are using.

twisted · #2 Post by **twisted** » Wed Mar 01, 2006 7:55 pm

Im kinda in the same boat, my chain is too small to fit with my new sprocket:(

So what do I do?

fixthedale · #3 Post by **fixthedale** » Wed Mar 01, 2006 8:05 pm

We run 14-38 sprockets and I think our chain is 94, not sure right this second, but we run a DID X-Ring on Moose Sprockets.

jesshamner · #4 Post by **jesshamner** » Wed Mar 01, 2006 8:20 pm

I guess I should mention that I'm running a 14t front and stock cannibal on the back. Not sure if stock is 42 or 43.

kdeal · #5 Post by **kdeal** » Wed Mar 01, 2006 8:26 pm

Stock is 13/42 on all but the Moto. DID X-Ring chain is an awesome chain. If you are buying new, get 100 links and keep the cut off piece for possible future gearing changes.

Jess,

Get a 40t rear for that new motor of yours to go with the 14t front, you are going to need it and the chain size can remain the same as stock.

jesshamner · #6 Post by **jesshamner** » Wed Mar 01, 2006 8:29 pm

Well, thats if I can get the new motor. I haven't been able to contact Timbo. I haven't tried calling him. I figure he is busy and I'm in no particular hurry right now so I haven't bothered him by calling. I guess I'll give him a shout sooner or later. But I need a new chain now. I get a good deal at my local shop on the chain and they cut it down for free.

wistech · #7 Post by **wistech** » Wed Mar 01, 2006 8:36 pm

Regina gold.....the only chain Ive ever seen live up to my expectations as well as Talon sprockets.

wistech · #8 Post by **wistech** » Wed Mar 01, 2006 8:37 pm

Send me your motor Jess . Ill beat a crank out of Tim next time I see him. We'll getcha going.

twisted · #9 Post by **twisted** » Wed Mar 01, 2006 8:55 pm

so I decided to buy a new chain, im running 14-stock cannibal rear, what links do I get? whats the stock chain +1?

Anyone good sites to order?

wistech · #10 Post by **wistech** » Wed Mar 01, 2006 9:12 pm

Yep you will need one more link for a 14 tooth. Its just a smidge to short for the adjuster.