Page 1 of 1
Posted: Thu May 18, 2006 1:01 am
by f15046
I seem to be having a problem with removing the injectors. My motor is ready to come out except I can't seem to remove the injectors from the intake ports. I thought they were supposed to just slide out. I have removed the metal retaining clip, and the wiring. If anyone can give me some tips. thanks
Posted: Thu May 18, 2006 2:24 am
by jwheat
They can be a pain sometimes. Have a friend LIGHTLY tap upwards on them with a hammer and flat-end punch while you pull on them. They'll usually come on out. When you go to put them back in, be sure and lubricate the o-rings on the injectors so they will slide in easier.
Posted: Thu May 18, 2006 2:59 am
by wistech
They can be a pain sometimes. Have a friend LIGHTLY tap upwards on them with a hammer and flat-end punch while you pull on them. They'll usually come on out. When you go to put them back in, be sure and lubricate the o-rings on the injectors so they will slide in easier.
A little spray silicone or any lube does wonders. Just hose them down and give em a wiggle.