Posted: Mon May 22, 2006 12:58 am
I am having a problem with my dale. All the sudden when I press the throttle in, the bike chokes and stalls. It was running fine this morning. I was practicing on an MX track, took a break, went back onto the track, hit the gas, and it started stalling.
So far, I have changed the plug, tried a different coil, replaced the fuel filter. We opened up the intake and by covering the hole on top of the motor with my hands I was able to give the bike full throttle without it dying. It dies as soon as the hand was removed. I have not tried a new fuel pump yet.
I got it home and hooked it up to my DM kit. I am gettig a MIL lamp open fault, I never used to get it, but I used to have a dash board with lights hooked up, and do not right now, so I think that is why I am getting this fault when I never did before. I also cannot recieve my calibration file. When I do it, the blue bar goes about 2/3, and a clicking sound starts happening somewhere near the top of the motor. The clicking sound happens rapidly like morse code. Eventually the ECU shuts down and the download fails. I am able to upload a file to the ECU.
That is all I have got, any advice would be greatly appreciated.
So far, I have changed the plug, tried a different coil, replaced the fuel filter. We opened up the intake and by covering the hole on top of the motor with my hands I was able to give the bike full throttle without it dying. It dies as soon as the hand was removed. I have not tried a new fuel pump yet.
I got it home and hooked it up to my DM kit. I am gettig a MIL lamp open fault, I never used to get it, but I used to have a dash board with lights hooked up, and do not right now, so I think that is why I am getting this fault when I never did before. I also cannot recieve my calibration file. When I do it, the blue bar goes about 2/3, and a clicking sound starts happening somewhere near the top of the motor. The clicking sound happens rapidly like morse code. Eventually the ECU shuts down and the download fails. I am able to upload a file to the ECU.
That is all I have got, any advice would be greatly appreciated.