Posted: Thu Jan 04, 2007 11:32 pm
Hey everyone,
I just bought a new motor for 02 moto and I'm going to sell mine. It had a rebuild done by ATK about 10 hours ago and runs strong. The only problem with it is that oil check ball valve is sticking now. I have been told it should fix itself but I haven't rode it enough latley to fix it. It is the Hydo clutch and I have all the receipts from ATK on the work done. Here is a list of what they did.
Rebuild Cannondale Engine: includes complete gasket set with seals, crank in good condition, and new piston and rings. -$1100
New Raw Engine Casings -$401.78
Engine Rail Weldment - $148.20
Bearing, 25x62x17mm, Plstc -$42.14
Ball Bearing - $8.99
Clutch Plate, Fri*DNB*, 22.32mm - $12.28
Cam Cover Assy - $157.86
Any help on what I can get for this would be great.
Thanks,
Eric
I just bought a new motor for 02 moto and I'm going to sell mine. It had a rebuild done by ATK about 10 hours ago and runs strong. The only problem with it is that oil check ball valve is sticking now. I have been told it should fix itself but I haven't rode it enough latley to fix it. It is the Hydo clutch and I have all the receipts from ATK on the work done. Here is a list of what they did.
Rebuild Cannondale Engine: includes complete gasket set with seals, crank in good condition, and new piston and rings. -$1100
New Raw Engine Casings -$401.78
Engine Rail Weldment - $148.20
Bearing, 25x62x17mm, Plstc -$42.14
Ball Bearing - $8.99
Clutch Plate, Fri*DNB*, 22.32mm - $12.28
Cam Cover Assy - $157.86
Any help on what I can get for this would be great.
Thanks,
Eric