Posted: Thu Apr 05, 2007 2:05 am
What is the stock compression on a dale and whats the lowest you can make with available parts?
Cannondaleriders
A safe place for quads older than the owners
https://cannondaleriders.com/phpbb/
Compression Ratios
https://cannondaleriders.com/phpbb/viewtopic.php?f=9&t=16604
Page 1 of 2
Posted: Thu Apr 05, 2007 3:03 am
A short rod falicon with an Asso piston should get you down there.
Posted: Thu Apr 05, 2007 3:10 am
Do you have any specs on these parts. I am looking for around 8-9:1. I didnt realize there were two different rods. Do the pistons have a different pin height?
Posted: Mon Apr 09, 2007 9:16 pm
I think I smell forced induction?
Posted: Mon Apr 09, 2007 10:05 pm
I think I smell sumthang too, but it could be that chili burrito I had for lunch too!
I hope it's forced induction if not that motor is going to be a pig, even with N2O.
I hope it's forced induction if not that motor is going to be a pig, even with N2O.
Posted: Mon Apr 09, 2007 10:57 pm
He has something in mind.
Posted: Tue Apr 10, 2007 1:34 am
Just get a shortrod Falicon and a TImbo cut stroker piston.Should be right around what you want.
Posted: Tue Apr 10, 2007 2:00 am
QUOTE (cannondale27 @ Apr 9 2007, 08:34 PM) <{POST_SNAPBACK}>
Just get a shortrod Falicon and a TImbo cut stroker piston.Should be right around what you want.
What is the difference in a short and a long rod falicon? (other than the rods) Do the pistons have different pin heights? What is a cut stroker piston? does he open the eyebrows a little more?
Posted: Tue Apr 10, 2007 2:00 pm
I have the short rod from a falicon if you want, no crank though.
Posted: Wed Apr 11, 2007 1:03 am
Tim (Timbomoose) can order you a piston at any C/R that your heart desires.