Page 1 of 1
Posted: Sat Aug 16, 2008 8:42 pm
by Denny08
Just got my Blaze put back together went to start just cranks. I checked all connections everything is where it should be, got spark, fuel pump is running while motor is cranking but I don't think the injectors are squirting is that possible. It was just a crank replacement so all I needed to do was set it at top dead center put the cams in the up location like it shows in the book put timing chain on and be good correct. So if anyone can help that would be good.
Posted: Sat Aug 16, 2008 9:38 pm
by claas900
One of the pages in the book is wrong, it's backwards. I think it's page 45? Are you sure you don't have the crank and water sensor pluged in backwards?
Posted: Sun Aug 17, 2008 1:13 am
by MyCannibal
injectors plugged all the way in?
Posted: Sun Aug 17, 2008 1:28 am
by thedeatons
Do a compression test if all those other suggestions check out good. You should have 90-100psi.
Posted: Wed Aug 20, 2008 9:31 pm
by Denny08
Do a compression test if all those other suggestions check out good. You should have 90-100psi.
found the prob fuel pump running just not pumping
Posted: Mon Oct 21, 2013 12:25 am
by Jasonboz56
found the prob fuel pump running just not pumping
How did you figure that out? Did you have to buy a new one? I'm having the same problem. My fuel filter has bubbles in it when cranking then drains mostly empty when not being cranked. Any advice? I have spark and good gas and battery but it just won't fire? I'm wondering if I have an air leak in the fuel lines but there's good fuel flow in the gas tank when cranking. The pump definitely primes but my plug doesn't get very wet and it doesn't really fire at all... My only thoughts are maybe the injectors from sitting if it's not the fuel lines...
Posted: Tue Oct 22, 2013 12:52 am
by speedracer
You can remove you pump and bench test it.Have you pulled your airfilter and looked down the throttle body while cranking to see if the injectors are spraying?