Page 1 of 1
How to check the Impeller?
Posted: Mon Jul 07, 2003 12:16 pm
by Dale512
How would I go about checking my water impeller? Can I do it with the Motor in the Chassis? Do I have to drain my coolant?
Thanks
Posted: Mon Jul 07, 2003 6:58 pm
by Big Winky
yes, you can check it in the frame, but dang is it ever tight (need small fingers). if you drain the coolant is also alot less messy, and make sure your pets can't get at the drained or spilled coolant cause they LOVE the stuff and it will kill them if they drink it.
Posted: Mon Jul 07, 2003 9:45 pm
by haydug
Hey Wink, how about an aluminum impeller, since I've seen some stripped before.
Posted: Tue Jul 08, 2003 6:52 am
by Big Winky
I have an alum impeller as a sample, been trying to come up with a cost effective way of making them.
Posted: Tue Jul 08, 2003 7:51 am
by haydug
Keep me posted, I'll take the first 12 or so if they are cost effective. Thanks
Posted: Tue Jul 08, 2003 12:03 pm
by Big Winky
will do, doug:D
coolant
Posted: Tue Jul 08, 2003 12:13 pm
by ppogue
Hey Dale,
remove all plastic and the tank, drain coolant, grab a 6 and 8mm wrentch, "that's right, they used two sizes" and remove the top two first. The furthest one forward is a pain, but use patience and you can get it. Easy removing the cover as there are tons of hoses and vents.
good luck,
?
Posted: Tue Jul 08, 2003 12:32 pm
by Dale512
Remove the bolts from what? lol, sorry.....just not all that sure about what I am doing.
Posted: Tue Jul 08, 2003 12:45 pm
by Ryanstones
water pump impeller is inside the water pump cover on the upper right of the head/valve cover. Since you've had overheating problems this is a good thing to check. You will also look for corrosion on the side of the valve cover, behind the impeller.