Few Issues after rebuild.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
I recently rebuilt my engine, had Tim fix the falicon crank, put it back together and made sure all the updates were done. I got the engine back in, I was letting it idle the other day (can't ride it yet as I still need to put balljoints in) and it's probably got 10 minutes of idle time, so I revved it up a little bit and it was fine until I went to about half throttle and it fell on its face and died. I cranked it back over and it didn't fire up but it did shoot a flame out of the intake and a small one out of the exhaust. Not at the same time though. I also sent Tim my ecu and throttle body and he put a map on it and recalibrated my throttle body. It almost seems as if it's flooding itself out. Thanks for any help.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
If the tank is stock, first check that the return hose is not fold-kinked at the male connector.
That's a common place for the hose to get creased. Sliding back the firesleeve there will often reveal the issue, past or present.
It can tend to fold when the tank is pushed down after connecting the fitting.
That's a common place for the hose to get creased. Sliding back the firesleeve there will often reveal the issue, past or present.
It can tend to fold when the tank is pushed down after connecting the fitting.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm