Page 1 of 1
How to CHECK VALVES?
Posted: Thu Dec 04, 2003 5:22 pm
by HOUSER CDALE
I have a service manual , it says something about shims? I have had my bike for over a year and wanted to make sure everything is still tight! All help is appreciated thanks !
Posted: Thu Dec 04, 2003 5:34 pm
by Jaybr
The shims are used to adjust the valves, they go under the valve buckets.
Check the valves per the instructions in the manual, and if their out, use the table in the manual to determine which shims you need.
Posted: Thu Dec 04, 2003 6:16 pm
by HOUSER CDALE
SO you have to buy new shims if there out of place? Where can i get them and how much do you they cost.
Posted: Thu Dec 04, 2003 6:27 pm
by Jaybr
You can probably get them from any of the dealers on this site, and they cost around $4-5 a piece from what I remember.
Posted: Thu Dec 04, 2003 8:02 pm
by J. Delaney
I seem to remember someone saying that the shims are the same as some Suzuki street bike. Can't remember which bike though.
Posted: Mon Dec 08, 2003 11:22 am
by 54warrior
I heard they were exactly the same as those for the Z400.
Posted: Fri Dec 12, 2003 1:17 pm
by Big Winky
There are 2 standard size shims used on most bikes 5mm and 9.5mm diameter of which the cannondale uses the 9.5mm diameter.
Posted: Fri Dec 12, 2003 1:21 pm
by jcv440
Yep, they're Suzuki ones. Your local dealer can also order them out of Parts Unlimited.