Page 1 of 2
I Made A Boo-boo!!!!!
Posted: Tue Jan 13, 2004 2:46 am
by bouncerdude
i had my motor out of my cannibal a few weaks ago, and apparently i had a long day because i stripped out one of the threaded holes for the left engine cover. and on top of that i didnt see that i had some crap in the threads of the transmission plug, so it wont budge in or out. i got so pissed that i let it sit in my garage for the past few weaks untill i got my patience back. i could really use some ideas on how to fix these, especially the trans plug because im kinda screwed if i cant get my filter in and out or my oil changed. i would really appreciate some help. thanks.
Posted: Tue Jan 13, 2004 1:10 pm
by cannondale27
The sidecover bolt just install a Helicoil of same size.Any auto store will have these.If the head on plug is still good use a propane torch to heat it up good and hot then use a six point socket or wrench.If head is shot already heat and try a vicegrip or cut a slot in it and use a big screwdriver with a wrench on shaft.
Posted: Tue Jan 13, 2004 2:22 pm
by haydug
Those sound like great ideas to me, almost like a "speaking from experience" kinda guy.
Posted: Wed Jan 14, 2004 12:05 am
by cannondale27
Yea some guys overdue it a bit.Neverseize really helps also.
Posted: Wed Jan 14, 2004 1:32 am
by bouncerdude
if there is any transmission oil in the engine do you think it will catch on fire or anything? i dont want to make a bigger mess than i have to.
Posted: Wed Jan 14, 2004 6:40 am
by dawzie
lay the motor on its side - propane tourch is the key word. Also, those side cover bolts/screws, there are short and long ones, get'em in the right spots.
Posted: Wed Jan 14, 2004 11:48 am
by bknight
i tryed this one it work for me
1. SYMPTOMS: Transmission plug is tight and will not come off
2. PROBLEM: the thing is just not made right, It needs a better plug
3. FIX: Us a large punch and hammer. Hit the center of the plug hard one or two times and it will spin off easy. The best time to do this is before you ruin the hex head on the plug.
Posted: Wed Jan 14, 2004 5:38 pm
by aroracer72
some people arnt shure what a punch is...or dont have one, for any 1 who doesnt know, its a screwdriver...but its very cool...you put the screwdriver tip in the head..and what it allows you to do is hit the back of it with a hammer....and when you hit it...it turns the screwdriver head..and breaks it loose....these work EXTREMELY well....and youd like to try this before heating.....or drilling, etc. Very cool gadget.
Posted: Wed Jan 14, 2004 5:52 pm
by dawzie
also known as a impact screwdriver - :hammer:
Posted: Wed Jan 14, 2004 8:55 pm
by aroracer72
yes...thats the name....i was trying to think of it.:hammer: