Clutch Actuator - Gone LIMP!

Message

Racin Red · #1 Post by **Racin Red** » Sun Feb 29, 2004 5:00 pm

Here it is, '02 Cannibal performed in Texas GNCC, snapped a clutch cable right at the lever. Got home went over the bike, replaced the the cable and found the actuator arm had gone limp! The spring is still in tact but when you push it forward it stays there. When you put it in gear and try to operate the the clutch at the actuator arm nothing happens. No disengaging. Anyone have any assumptions:confused:

iceracer17 · #2 Post by **iceracer17** » Sun Feb 29, 2004 6:26 pm

The end of the actuating shaft end probably wore through.Try taking the actuating arm out of the case and check the bottom of it.

Ryanstones · #3 Post by **Ryanstones** » Sun Feb 29, 2004 6:59 pm

Maz has actuating shafts. If you have any trouble getting him let me know and i'll send you one of my spares.

jfarrar · #4 Post by **jfarrar** » Sun Feb 29, 2004 10:43 pm

think viagra will help it?

Racin Red · #5 Post by **Racin Red** » Mon Mar 01, 2004 1:41 am

maybe I'll try it, anyone spare the little blue pill:)

Cannondaleriders

Clutch Actuator - Gone LIMP!

Clutch Actuator - Gone LIMP!

that's prrobably it.