Clutch Plates sharp or round side
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Clutch Plates sharp or round side
hey last time i put a clutch in i was told to put the sharp sides of the metal plates in one direction and the rounded off side in the other i dont remember which side goes in which direction can somoen help me out with that???I also read on here somethin about rubbin the metal plates on the floor to roughen them up is that true or not?
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
sharp edges go in on all plates and washers ,and scuffing plates is good idea just make sure you inspect for warped plates and or glazed, clean with contact cleaner after. inspect tabs for wear and look at basket for notched or cracked webs.just dont over tighten when reassemling and make sure pessure plate is seated correctly before tightening or clutch wont engage properly and will have to be reassembled.
Go, LB, Go!!!!
I don't believe I'd be using the floor to scuff the plates! If they're used, try a Scotchbrite pad. If they're new, just put 'em in, unless there's some surface rust or something on there that obviously doesn't belong, then revert back to the Scotchbrite pad.
Don't forget to coat the fibers with oil before assembling. I usually drop them, one by one, in a coffee can with oil when I start, then by the time I have the old ones out, they're ready to go. They don't need to "soak" for a certain time, just make sure they're coated. Dry plates are a bad thing. Other than that, follow LB's advice.
Don't forget to coat the fibers with oil before assembling. I usually drop them, one by one, in a coffee can with oil when I start, then by the time I have the old ones out, they're ready to go. They don't need to "soak" for a certain time, just make sure they're coated. Dry plates are a bad thing. Other than that, follow LB's advice.
speaking of clutch plates
I had my inner most friction plate torqued a little bit from hard starts during drag racing and bought a replacement plate. But the replacement I got had silver tabs and the stock had bronze colored tabs. Anyone know if the material makes a difference.
Sharp edges on metal plates?
After I read this I went and looked at the new plates that I got from Haydug. I didn't see a sharp side and a round side. I guess I am looking at the right plate, drive plate. Although, I will be installing aluminum drive plates instead of the metal ones. Does this make a difference, as far as sharp edges go?
After I read this I went and looked at the new plates that I got from Haydug. I didn't see a sharp side and a round side. I guess I am looking at the right plate, drive plate. Although, I will be installing aluminum drive plates instead of the metal ones. Does this make a difference, as far as sharp edges go?
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm