Exhaust for stock mapping?
Posted: Sat Jun 12, 2004 5:26 pm
I was wondering if there is a full exhaust available that will run on an 02 speed with the stock EFI mapping. If not what can I use if anything with the standard map?
Cannondaleriders
A safe place for quads older than the owners
https://cannondaleriders.com/phpbb/
Exhaust for stock mapping?
Page 1 of 1
Posted: Sat Jun 12, 2004 8:29 pm
its difficult to use a full exhaust system without remapping ( rejetting ). u will be too lean if u install the pipe and keep stock map. if u dont want to by the d&m kit. send the ECU to Maz or haydug and they can install a good map
Posted: Sun Jun 13, 2004 6:02 pm
So I guess I am better off buying the DM kit and probably the moto/speed map. I have heard that is probably the best map out there. So with the moto/speed map what would then be usable as a full system, and which comes most recommended?
Posted: Sun Jun 13, 2004 7:10 pm
yes, i say get the d&m. the moto/speed is good, blaze/speed is also good. maz's xmx is fun!
and they say the nacs maps are also pretty snappy. thomez has a pretty wicked out there also. the hmf is probably the most popular full system out there now. it's a little loud so get the quiet core.
and they say the nacs maps are also pretty snappy. thomez has a pretty wicked out there also. the hmf is probably the most popular full system out there now. it's a little loud so get the quiet core.MAP
Posted: Fri Jun 18, 2004 1:50 am
What are the differences between the Moto/Speed and the Blaze/Speed?
I have a Glamis with 03 header and open alum slip on, which is best for sand dunes and paddles?
I have a Glamis with 03 header and open alum slip on, which is best for sand dunes and paddles?
Posted: Fri Jun 18, 2004 2:00 am
the moto has more lowend snap than the blaze. so the moto/speed would probably be the one for you.