Cannondaleriders

Hey, i got my d&m from haydug (quick arivial) :clap: then i called timbo and got my mapping all worked out, no i beleive its not getting any fuel it wont start, the fuel pump kicks on, it has gas , i think its air locked somewhere, happen to anyone else? should i try and spray some starting fluid in the spark plug hole and see if it hits? Their is very little fuel in the filter, its just at the bottom of the paper in the filter, not up to the holes yet, let me know what u guys think

Look into you gas tank when the fuel pump turns on, there should be a pretty healthy stream shooting out of the return line. If not there might be a blockage or pinched line or something.

Also double check your gas tank fittings to be sure they are hooked up correctly.

Same things goining on with my cannibal. I still haven't figured it out . I thought if you would put it on a D&M it would tell you whats wrong with it. When you hook your D&M up it doesen't give you any faults? I don't have a D&M to put mine on so maybe if you figure out what's wrong with yours same thing could be wrong with mine. My cannibal fired up when I used starter fluid.

If the fuel pump turns on the Hex is almost always good.If a map along with all the settings wasnt loaded in it would also do this.A D&M will allow you to check or reload this along with sensing a injector fault.If all that checks out which 440speed probably did then it must be one the things mentioned or a bad fuel pump.Without D&M it is tough to know anything for sure.

tomarrow when i get home ill hook it up to my d&m and see what it says, ill re load my new map and check for faults. Whats it mean when it reads an injector fault?

The injectors are probably bad. Or there not connected up right.

im ganna hook it up the the d&m tomarrow and we will see what it says

When was the last time your quad ran and what happened to it?
Did you check the basics? Fuel pressure,spark,Battery connections good?

try a new coil. Trust me. :drink: