Page 1 of 2
fault code
Posted: Sun Mar 20, 2005 9:31 pm
by steve-222
what does MIL lamp open fault code mean on an 02 c440?
we hooked up the D&M and in gave us this code. We also installed a new map the bike went a hundred yards and will not start back up.
Posted: Sun Mar 20, 2005 9:43 pm
by Happyboy
that code has to do with the map select kit...it is ok to have that code showing up.
Posted: Sun Mar 20, 2005 10:56 pm
by c41xracer
MIL lamp open is the head lights or tail light is unplugged
Posted: Sun Mar 20, 2005 11:14 pm
by steve-222
cool on thre code but the bike still wont start. we put the harrymoto 120 10,000 map on it. also at 2100 rpm my voltage was reading 14.0 and higher, that seems a little high to me.
Posted: Sun Mar 20, 2005 11:47 pm
by Happyboy
Um I dont' think the MIL lamp fault has anything to do with the tail light or headlights...
MIL Lamp open or short failure happens everytime you run diagnostic...it is looking for the GP Map Select Kit
Posted: Mon Mar 21, 2005 2:24 am
by kdeal
Happyboy is right, it has to do with the status lights in one of the higher end D&M kits. This is a normal fault code in most applications. I also believe ****** is right, after you got the this is a diiferent cal message did you use all the fault codes from the computer and not the map? If not Try mapping back to the original map to see if the map was the problem.
Posted: Mon Mar 21, 2005 3:04 am
by steve-222
what do you mean fault codes from the computer and not the map?
Posted: Mon Mar 21, 2005 3:25 am
by steve-222
what do you mean fault codes from the computer and not the map?
Posted: Mon Mar 21, 2005 12:06 pm
by steve-222
can I change all of these numbers? and what would be the basic numbers that I would want to input?
Posted: Mon Mar 21, 2005 2:18 pm
by theJeStEr1340
The ones that were there before you changed the map. Did you write them down?