Won't Start / Nothing

Message

Lippy91 · #1 Post by **Lippy91** » Mon Mar 28, 2005 1:23 am

I turn the key and NOTHING... I went out and bought a new battery and charged it up threw it in the quad, turned the key on and NOTHING!! Neither battery works , so I can rule out the battery.

Now What???

At the last race , last year, same thing went and turned it off to talk to the folks then turned the key right back back on and NOTHING...

The fuel pump doesn't turn on. What a bummer, I start the race season next week and....

1.Quad wont start.
2.03' Silencer won't fit on the 03' Bill's silencer.
There's less than 1/2 inch between the end of the headpipe and the subframe.

I can only guess that I have a bent subframe since the headpipe is new.

Any help would be great help!!!

Lippy91 · #2 Post by **Lippy91** » Mon Mar 28, 2005 1:36 am

Fuse is good.

dalewannbe · #3 Post by **dalewannbe** » Mon Mar 28, 2005 1:41 am

Do you have a tether? If so make a jumper wire to eliminate the tether. My teather wires were loose and my quad did nothing, like you are describing.

Lippy91 · #4 Post by **Lippy91** » Mon Mar 28, 2005 1:52 am

Where were they loose??

dalewannbe · #5 Post by **dalewannbe** » Mon Mar 28, 2005 2:06 am

I had bullet connectors on mine, so it could plug into the wiring harness. They were loose at the bullet connectors. They are now soldered.

cannondale27 · #6 Post by **cannondale27** » Mon Mar 28, 2005 12:35 pm

Main power relay.(one under filter)

http://www.cannondaleriders.com/vbb/showth...&threadid=11222

Lippy91 · #7 Post by **Lippy91** » Mon Mar 28, 2005 4:51 pm

Any other fuses??

NRath · #8 Post by **NRath** » Mon Mar 28, 2005 5:04 pm

QUOTE

Originally posted by Lippy91
Any other fuses??

Nope.

I'd suggest checking for power at and through the switch with a voltmeter. At the same time you'll be checking those bullet connectors dalewannabe mentioned.

Lippy91 · #9 Post by **Lippy91** » Mon Mar 28, 2005 5:33 pm

Connecters were fine, Relay was dirty as **** . Southwick sand , cleaned but still no go.:mad:

claas900 · #10 Post by **claas900** » Mon Mar 28, 2005 7:49 pm

.. tether switch or key switch.