Denton stabilizer mount

Message

KYmxracer52 · #1 Post by **KYmxracer52** » Thu Jul 28, 2005 11:13 am

Does anyone know of a replacement rubber bushing I can put in my denton stabilizer? I have the original one and the rubber mounted end that attaches to the stem has a lot of slop in it. Its the piece right at the end of the piston. Any ideas?

cannondale27 · #2 Post by **cannondale27** » Thu Jul 28, 2005 11:33 am

It is a nonredbuildable Denton right?If so I will take a look at mine and see if I can make you a bushing.One in there may be a permanent type like molded in so it might take some work to get it out.

KYmxracer52 · #3 Post by **KYmxracer52** » Thu Jul 28, 2005 7:50 pm

yeah, I hate to buy a whole new stabilizer just for the worn bushing. I was thinking of maybe taking some rubber and drilling a hole in the middle and putting the metal sleeve in it and just using a big washer on the top and bottom of the bushing with the bolt through it to hold it in.

cannondale27 · #4 Post by **cannondale27** » Fri Jul 29, 2005 2:10 am

That would work great.You could make it out of Polyurethane to make it last longer.No reason for rubber in there.