QUOTE
Originally posted by Brad Oakley
But... Let's remember that you no longer have the WWE piston. When Tim tried to mill it, he accidentally cut into the ring groove while cutting a valve pocket.
You can use the WWE 450 and 460 kits, but you should do it with the Falicon stroker crank. The pistons just won't accept having 2mm cut off their tops.
But... Let's remember that you no longer have the WWE piston. When Tim tried to mill it, he accidentally cut into the ring groove while cutting a valve pocket.
You can use the WWE 450 and 460 kits, but you should do it with the Falicon stroker crank. The pistons just won't accept having 2mm cut off their tops.
FYI: On a 2mm stroker crank you would only need to mill 1mm off of the top of the piston as the stroke is made up of 1mm upstroke and 1mm down stroke. Wade's pistons are very light, he removes a lot of material from them.
Because Timbo mills material off of the top of the piston it allows him to reshape the top of the piston to allow higher compression if you want.