advice on building a work bench
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
advice on building a work bench
Ok.. so I am now a month into my house and it is time for me to build a work bench. What I am looking for is advice, suggestions, photos and tips.
The work bench is mainly going to be used as a general purpose, perhaps a motor or two here and there. Not looking to break the bank, just build a bench that is going to be functional and sturdy.
One feature that I would like to build into this bench is cutout area that has a metal mesh cover. This feature would be useful when opening a motor, oil can just flow into the mesh screen and into a bucket area.
also what would be a good vice to purchase, one that doesn't break the bank
The work bench is mainly going to be used as a general purpose, perhaps a motor or two here and there. Not looking to break the bank, just build a bench that is going to be functional and sturdy.
One feature that I would like to build into this bench is cutout area that has a metal mesh cover. This feature would be useful when opening a motor, oil can just flow into the mesh screen and into a bucket area.
also what would be a good vice to purchase, one that doesn't break the bank
Forget the mesh cover . Get a very heavy galvanized sheet metal top custom made for it . Have it made to curl down over the edge and under the bench. A local sheel metal /heating and cooling shop can make them for you. The mesh cover will be a pain and you willl loose lots of tiny little parts in it.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
I built mine just for me. Bend your arm 90 degrees at your elbow and measure from the floor to an inch or so below your hand. That's where you want your work surface.
I used 2x4s for the top of mine, made sure to get straight ones, and screwed in the first one then used pipe clamps to get the next one in good and tight before screwing it in. Makes for a very sturdy work surface, and if it ever gets chewed up to the point of being unusable, it is very cheap and easy to replace. Just unscrew the bad boards, and screw in new ones in their places.
Marc
I used 2x4s for the top of mine, made sure to get straight ones, and screwed in the first one then used pipe clamps to get the next one in good and tight before screwing it in. Makes for a very sturdy work surface, and if it ever gets chewed up to the point of being unusable, it is very cheap and easy to replace. Just unscrew the bad boards, and screw in new ones in their places.
Marc
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm