Engine, intake, exhaust, EFI, chain, sprockets, etc.
Speed 1B
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#1
Post
by Speed 1B » Fri May 30, 2003 11:07 pm
Has anyone ever tried to tackle this project? If so how hard of a project is it? different swingarm and axle i know....what about a pipe? Can it be done?
Knight440
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#2
Post
by Knight440 » Sat May 31, 2003 5:34 am
I think one of the bigger problems would be no room for carb and air box:confused:
JST
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#3
Post
by JST » Sat May 31, 2003 9:35 am
The axle might not be a problem ,the sprocket hub and drake disk hub are identical.
Speed 1B
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#4
Post
by Speed 1B » Sat May 31, 2003 10:41 am
You could run the 450 fuel injected like the cannondale. Optimum makes a kit!!
JST
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#5
Post
by JST » Sat May 31, 2003 2:02 pm
This is starting to sound possible.
jcv440
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#6
Post
by jcv440 » Mon Jun 02, 2003 7:11 am
i don't see how the kickstarter is going to fit though. It was brought up in another forum. I'd use the new YZF450 WR engine.