Ball Joint sleeve for LSR and Diamond Racing Arms
Ok, I really hate to admit this, but I have a set of Diamond Racing Long Travel arms for my Cannondale. I ran into a set that a guy was almost giving away and thought, hey why not. So after spending less than 150 on them I found out why he was giving them away. LOL The arms came with no sleeves in the bushings and the upper ball joint is to small for the spindle. I think I am going to try them out for a bit, before I sell them and buy a Leager T-pin setup like I should have done in the first place. What I need to know is, does someone make the sleeve for those balljoints, or a different ball joint I could use? I'd like to keep this project cheap since I'm selling them in a few months. Thanks for any help.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm