Sprocket Snap Ring

Message

wright · #1 Post by **wright** » Thu Oct 26, 2006 10:09 pm

Dose anyone know were i can get a snap ring for the outer edge of the sprocket hub, What is compatibal, one from a 400ex or some other quad
Thanks

mydreamride · #2 Post by **mydreamride** » Fri Oct 27, 2006 2:39 am

Actually the ones for a 400ex do fit. Thats what I'm using now and it's holding really well for over a year of use so far. The only difference I saw between the two is the 400ex clip is a little smaller than the stock ones is diameter wise.

wright · #3 Post by **wright** » Fri Oct 27, 2006 3:04 am

QUOTE (mydreamride @ Oct 27 2006, 02:39 AM) <{POST_SNAPBACK}>

Actually the ones for a 400ex do fit. Thats what I'm using now and it's holding really well for over a year of use so far. The only difference I saw between the two is the 400ex clip is a little smaller than the stock ones is diameter wise.

Thats just what i wanted to hear, i figued something else had to fit, Thanks for the help

cannondale27 · #4 Post by **cannondale27** » Fri Oct 27, 2006 7:58 am

cool thats good to know.Will add that to the FAQ section.Mydreamride does the 400ex caliper mount fit also?

speed2424 · #5 Post by **speed2424** » Fri Oct 27, 2006 2:21 pm

Cannondale 27, I believe Ross "Wright" was referring to the snap ring that goes onto the axle to hold the sprocket hub in place (1 1/2"). Not to hold the carrier in place (3").

cannondale27 · #6 Post by **cannondale27** » Fri Oct 27, 2006 2:29 pm

Oh that could be.Is that right Wright?

wright · #7 Post by **wright** » Fri Oct 27, 2006 2:38 pm

QUOTE (cannondale27 @ Oct 27 2006, 02:29 PM) <{POST_SNAPBACK}>

Oh that could be.Is that right Wright?

Ya thats what im looking for, the little one kind of like a peace of coat hanger, that goes on the outside, would be the right outside of the sprocket hub, if you were at the back of quad and looking at the axle. Hpoe this is the same one mydreamride is talking about, think so

cannondale27 · #8 Post by **cannondale27** » Fri Oct 27, 2006 3:02 pm

Yes it would be.Brain fart on my part.Thanks speed 2424

mydreamride · #9 Post by **mydreamride** » Fri Oct 27, 2006 4:50 pm

Yes the one I was talking about is the small steel wire clip to keep the disk hub from sliding to the side. I've tried the caliper mount before but it didn't fit due to a few things being different in design.

wright · #10 Post by **wright** » Thu Nov 02, 2006 3:35 am

QUOTE (mydreamride @ Oct 27 2006, 04:50 PM) <{POST_SNAPBACK}>

Yes the one I was talking about is the small steel wire clip to keep the disk hub from sliding to the side. I've tried the caliper mount before but it didn't fit due to a few things being different in design.

Thanks (mydreamride) that clip works great for the sprocket hub, i finely got my rear carrier back together from the group ride in PA. man what a long time its been, Thanks agian