Actually the ones for a 400ex do fit. Thats what I'm using now and it's holding really well for over a year of use so far. The only difference I saw between the two is the 400ex clip is a little smaller than the stock ones is diameter wise.
Actually the ones for a 400ex do fit. Thats what I'm using now and it's holding really well for over a year of use so far. The only difference I saw between the two is the 400ex clip is a little smaller than the stock ones is diameter wise.
Thats just what i wanted to hear, i figued something else had to fit, Thanks for the help
Cannondale 27, I believe Ross "Wright" was referring to the snap ring that goes onto the axle to hold the sprocket hub in place (1 1/2"). Not to hold the carrier in place (3").
Ya thats what im looking for, the little one kind of like a peace of coat hanger, that goes on the outside, would be the right outside of the sprocket hub, if you were at the back of quad and looking at the axle. Hpoe this is the same one mydreamride is talking about, think so
Yes the one I was talking about is the small steel wire clip to keep the disk hub from sliding to the side. I've tried the caliper mount before but it didn't fit due to a few things being different in design.
Yes the one I was talking about is the small steel wire clip to keep the disk hub from sliding to the side. I've tried the caliper mount before but it didn't fit due to a few things being different in design.
Thanks (mydreamride) that clip works great for the sprocket hub, i finely got my rear carrier back together from the group ride in PA. man what a long time its been, Thanks agian