Custom stators
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE (polyesterpig @ Dec 15 2006, 11:32 PM) <{POST_SNAPBACK}>
You could use "rare earth magnets" like trailtech does on their flywheels. This would bump up the power. http://trailtech.net/store/motorcycle_flywheels.html
What do you use to insulate the winding from the core.I have a ststor that is grounded to core?I `ve been having battery running down at times,thought it was battery,but found windings loose around core,you can shake stator and it will show ground on 2 phases,if you hold it still,shows clear.The weird thing was it was showing good voltage when on machine with engine running.I was checking windings with ohm meter before i put in new battery is only reason i found this. I was reading 2.5 ohms between 2 phases and 0 on other phases.I took stator off and cut harness close to stator and found it wasnt the harness. This cannondale is driving me
The metal core has a epoxy coating on it . The wires themselves are also coated with a clear epoxy resin. If they are damaged from heat or physical damage they will short to ground and cause the stator to not work at all. The issue with parts like these is if there is a break or short anywhere in the winding it almost impossible to get at it to repair or even find the exact location of the short. Hence a full rewire is in order. If the flywheel is extremely close and rubing on the stator crank endplay while the engine is running will cause intermittant charging because the flywheel is walking side to side a few thousanths.
QUOTE (haydug @ Dec 15 2006, 07:01 AM) <{POST_SNAPBACK}>
I thought Happyboy had already worked something out with Ricky Stator to do this?
What ever became of that? Did they do any ? What happened to that bike stator I sent you. Do you remember if it was a 2 or 3 wire. Was that the one he said was maxed out or did he get a quad stator as well? I just got some bike stators that are epoxy encapsulated instead of coated. Those seem the way to go .
They did 1 as a prototype and it worked fine. They were ready to go do a batch of them but at the time noone seemed to want to get it done. For the price you can just get a used one right now. It was the quad stator that he said was pretty much maxed out. As for the bike stator, I have no clue what happened to it. I guess Ricky kept it.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Hey John here is that post you missed with the double stator and steel flywheel.
http://www.cannondaleriders.com/forums/ind...topic=17828&hl=
http://www.cannondaleriders.com/forums/ind...topic=17828&hl=