![smile.gif](http://www.cannondaleriders.com/forums/style_emoticons/<#EMO_DIR#>/smile.gif)
engine dimensions
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
would i not be able to use the EFI off the dale?? if not, why? and, exhaust i would think would be easy enough to fabricate, seeing as there would be no airbox in the subframe so there would be plenty of space... the intake i'm not sure about.... my friend has a yzf lsr chassis, so i'll go measure and see what should and shouldn't fit where....we'll see. if i do it, it won't be for awhile because of the $$$, but i would certainly take a ton of pictures. thanks again for the input... more is welcome and appreciated. ![smile.gif](http://www.cannondaleriders.com/forums/style_emoticons/<#EMO_DIR#>/smile.gif)
![smile.gif](http://www.cannondaleriders.com/forums/style_emoticons/<#EMO_DIR#>/smile.gif)
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
well after a quick couple measurements of my friend's yz lsr chassis....it would be a tight fit, maybe have to notch the frame a slight bit, but other than that i think it would be alright. we also measured his 86 R frame, and i don't see how we'd fit it in there...i think the gap from the top to bottom frame rails was like 14 or 15 in? too short... the yz chassis seemed good though...right around 17, maybe a hair more
so wanablaze(or anyone else)...how come the cannondale EFI wouldn't work?
so wanablaze(or anyone else)...how come the cannondale EFI wouldn't work?
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
The head should fit between the rails of YFZ chassis its tight but will make it so hieght should be okay.Only issue with fuel injection is if there is room for throttlebody.Will it clear stem,radiator or bar behind it?The 17in tall included the very bottom of motor so some could fit between bottom rails also.Just so it isnt below them.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
hmmm...so basically, the only way to know for sure is to just buy it and try. ****. haha...well, when i have the money i'll pick up a motor, and we'll try and test fit it into his lsr, and if that seems like it'll work, i can invest in my own chassis. if it doesn't seem like it'll work, i can always build up a dale instead....
if anyone has any other ideas/suggestions/input/whatever, please post![smile.gif](http://www.cannondaleriders.com/forums/style_emoticons/<#EMO_DIR#>/smile.gif)
thanks again
if anyone has any other ideas/suggestions/input/whatever, please post
![smile.gif](http://www.cannondaleriders.com/forums/style_emoticons/<#EMO_DIR#>/smile.gif)
thanks again
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm