Well, now it is 20% lighter than a stock one, or should I say a stock one is 25% heavier than this one....? (no magnets in either at this point of course)
If the magnets that we end up using ultimately have the same OD as, or smaller than, the stock one I should be able to shave quite a bit more weight off too. As it is, this lightened flywheel can still take a magnet with an OD of 106mm, yet the stock OD is just under 102mm. So 2mm+ could be taken from much of the periphery with a stock magnet installed.
![smile.gif](http://www.cannondaleriders.com/forums/style_emoticons/<#EMO_DIR#>/smile.gif)