My first Cannondale
Well, the cannondale still will not star.I rechecked flywheel,it looks fine,I did not pull the flywheel to check stator I do not have a flywheel puller yet.I disconnected regulator from stator and tried to start.I sprayed ether , no go.It will occasionally pop through the throttle body and I can see fire in the hole.
Will a D&M kit help me figure out what is going on?I just picked up an engine service manual , hoping it will help me figure things out.
Any additional suggestions would be great.
Does anyone know of someone in the chicago area that they could reccomend to fix the quad if I can't figure this out.
I really don't want to part it out.
Thanks again.Gary.
Will a D&M kit help me figure out what is going on?I just picked up an engine service manual , hoping it will help me figure things out.
Any additional suggestions would be great.
Does anyone know of someone in the chicago area that they could reccomend to fix the quad if I can't figure this out.
I really don't want to part it out.
Thanks again.Gary.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Next chapter.
I did compression test it read 60 psi dry, 70 psi wet.While I was cranking to do the compression test The motor locked up and would not crank,you could hear the starter click.I took a large pair of channel locks and turned engine back a 1\4 turn then it would crank again.It did this twice ,now I'm not sure if I want it to start for fear of a major engine melt down. Any advice from anyone would be grateful.Thanks .Gary
I did compression test it read 60 psi dry, 70 psi wet.While I was cranking to do the compression test The motor locked up and would not crank,you could hear the starter click.I took a large pair of channel locks and turned engine back a 1\4 turn then it would crank again.It did this twice ,now I'm not sure if I want it to start for fear of a major engine melt down. Any advice from anyone would be grateful.Thanks .Gary
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
I'm trying to contact the previous owner to see if he will shed any light on this bike.I would like to find out what ,if any, work thats been done on motor .This will help me decide if I should repair the problem or send motor to get rebuilt altogether.If the motor has to come out I might as well get it done properly.
I would like to thank all those who have read the posts and helped me along.
Gary
I would like to thank all those who have read the posts and helped me along.
Gary
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
That sucks . I think everyone here on this site has done some kind of motor work on there quads. If you are willing to spend a little bit there is some very good engine builders on this site. Wistech , Timbo , Cannondale27 are the ones I have dealt with and they have been great . My advise to you is to send your motor out whole and have them take it apart and tell you what you need . Just my 2 cents !
i agree with cdale55. My recommendation would be to send the motor out to have it looked at,and not part out your quad. A experienced person might crack your engine open and find a simple problem that can easily be fixed. Buying a used engine might not be the best solution either because you don't always know what you are getting and you could wind up making an expensive mistake. There are plenty of reputable people on here that would easily be able to tell what is wrong with your motor and make it right.
just my opinion
just my opinion