Got Walsh?
I have been in the garage all morning cooking up a few sets of freshly powdercoated Walsh A-Arms. I used to do some PC work on the side for others, but NOW I remember why I hated doing it. Girlfriend was complaining about the smell too I told her these are much better than her co-workers christmas cookies
These will be going on my matching race and practice bikes for 2008
Pics will come as soon as they cool down.
On a side note I found a source of the teflon lined spherical bearings that are over HALF the cost Walsh charges. They want $20 each..x 8 = $160 Picked up 8 for under $60. If someone wants to know the part numbers I will be more than happy to share.
These will be going on my matching race and practice bikes for 2008
Pics will come as soon as they cool down.
On a side note I found a source of the teflon lined spherical bearings that are over HALF the cost Walsh charges. They want $20 each..x 8 = $160 Picked up 8 for under $60. If someone wants to know the part numbers I will be more than happy to share.
The Evol bike will be my race machine, the moto ohlins machine will be a sort of replica Nacs Moto. Once these are done I need to get crackin on the other two
[attachment=5240:08_Canno...ilds_003.jpg]
[attachment=5238:08_Canno...ilds_005.jpg]
Looks like a slight camber adjustment is in order
[attachment=5239:08_Canno...ilds_002.jpg]
[attachment=5240:08_Canno...ilds_003.jpg]
[attachment=5238:08_Canno...ilds_005.jpg]
Looks like a slight camber adjustment is in order
[attachment=5239:08_Canno...ilds_002.jpg]
QUOTE (2000ex @ Dec 23 2007, 09:12 AM) <{POST_SNAPBACK}>
Mike, did you ever get those to fit?
The part number is COM12T. Try sourcing them at your local bearing shop for less but online they are about $9-10/each.
The part number is COM12T. Try sourcing them at your local bearing shop for less but online they are about $9-10/each.
Yes, I did. Come to find out I have honda upper arms and I had to switch to honda spindles and hubs. I had to get the elka bodies shortened to the length. But now everything is good now. I hope!!!!
Thanks for the part #, My I wish I could afford the fox shocks.
On a side note I found a source of the teflon lined spherical bearings that are over HALF the cost Walsh charges. They want $20 each..x 8 = $160 Picked up 8 for under $60. If someone wants to know the part numbers I will be more than happy to share.
[/quote]
Have you found a source for the upper and lower heim ends. I know the uppers are 7/16 and the lowers are 1/2.
Mike
[/quote]
Have you found a source for the upper and lower heim ends. I know the uppers are 7/16 and the lowers are 1/2.
Mike
Everything can be found at http://www.rodendsupply.com/RodEndCatalog.pdf