Roll Design LT a-arms from 400ex working with dale spindles??
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Hi,
I used the Roll Design +3 (or +4 I forgot) with the ball joints for the 400ex. I bought the steel adapter sleeves from Canniboomer. They make the taper of the 400ex ball joints a bit more steep and allows them to work with the Cannondale spindles. It does require you to adjust the camber out quite a bit. Also, the 400ex pivot points are narrower than the Dale frame bosses. This was easily fixed by buying a few washers and shimming the pivots until them are snug. I haven't noticed any bump-steer or other issues.
God bless...
Mark
I used the Roll Design +3 (or +4 I forgot) with the ball joints for the 400ex. I bought the steel adapter sleeves from Canniboomer. They make the taper of the 400ex ball joints a bit more steep and allows them to work with the Cannondale spindles. It does require you to adjust the camber out quite a bit. Also, the 400ex pivot points are narrower than the Dale frame bosses. This was easily fixed by buying a few washers and shimming the pivots until them are snug. I haven't noticed any bump-steer or other issues.
God bless...
Mark
QUOTE (joedirt @ Feb 25 2008, 01:19 PM) <{POST_SNAPBACK}>
If you can use 400ex front A-arms do it. If you use 400ex spindles I think you mess up the whole geometry as far as bumpsteer and caster. Do it there is plenty of 400ex stuff out there
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Hi,
My Roll Design set is a Long Travel setup, so I bought some Works Performance 19.75" shocks (Also fits Honda trx450) I also had to use washers to shim the top
GOd bless...
Mark
My Roll Design set is a Long Travel setup, so I bought some Works Performance 19.75" shocks (Also fits Honda trx450) I also had to use washers to shim the top
GOd bless...
Mark
QUOTE (jesshamner @ Feb 25 2008, 09:15 PM) <{POST_SNAPBACK}>
Thanks for the info guys. Using cdale shocks or 400ex?
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm