Shocks, a-arms, swingarms, tires, brakes, etc..
KYmxracer52
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#1
Post
by KYmxracer52 » Sat Aug 09, 2003 2:41 pm
What PSI do most peole run in the Holeshot MX's? I've always run Grooved Rikens and I bought me a set of the Holeshots, so I'm not sure what should be put in them. You usually run more in the Rikens.
KYmxracer52
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#3
Post
by KYmxracer52 » Sat Aug 09, 2003 8:22 pm
I'm talking about the front tires, in case I confused anyone, but no, I'm not running beadlocks. Just the Douglas Ultimate fronts.
justfine
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#4
Post
by justfine » Sat Aug 09, 2003 9:09 pm
12 in the front and 6 in the rear as a rule. Might change rear for track conditions.
haydug
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#5
Post
by haydug » Sun Aug 10, 2003 3:13 pm
12 sounds pretty close, but I have ran as high as 15 and went to 10 for some mud. Are you running 19" or 20"
josborn
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#7
Post
by josborn » Tue Aug 12, 2003 2:29 pm
I run on ohio clay, and use 10-12 in the front (holeshots) and 8-10 in the rear (tamers). Just depends on how soft or hard the track is.
KYmxracer52
Posts: 0 Joined: Wed Mar 10, 2021 10:41 pm
#8
Post
by KYmxracer52 » Tue Aug 12, 2003 2:58 pm
Well, the track I run on is clay as well. It starts out pretty loose, but as the laps proceed, it gets a blue groove in the corners.