I just got the motor in the frame. Installed new injectors and go to start the dale. It ran for 30sec and died like it was starving for fuel. I checked all my conections no problems. I just put on boomers tank and his pod air filter setup. Changed the plug with a new one. Changed the coil with one I had layin around.
So after all that I got the laptop out and checked the fault codes, Both my injectors have an open fault??
Im out I ideas... Please help!!!
Oh yea this is a new piston. I had the same fault codes with the old injectors?
did it restart after it died?probably a dumb suggestion but is the return line connected?make sure all your connections are good,you may need to adjust your throttle as well..
I called and got the answering machine. Pretty iffy to get a head sent out tommorrow and delivered and installed by teusday. A whole lot of things would need to go perfect for that to happen. I should have the ported head done in a couple days. Can you borrow a quad for the trip? A dale should still start at 60psi . 50 is the absolute minimum though . Can you do a leakdown test and see if its leaking through a valve or the piston? My number is 1 715 551 1498
I checked the flywheel it is good. checked for spark and it is good. I did do a leakdown test and can here air comming out the intake valves. So back to pulling the motor again...
Wistech,
I will call in the A.M. to get that head sent my way.