Pictures from the mess inside my engine
I checked the valves. Exhaust valves are bend. So I'm gonna use antoher head. I have one with low hours, valves are good and no sticky valve buckets.
Is it safe btw to use the cams from my other head? Those have been timed and have good auto-decomp.
I will have the bottom-end ready today. I have a early style H-beam crank wich is from a X440S wich has been ridden once, so the shaft and rod are perfect. I installed a Z400 bearing and pressed it together 15 minutes ago. This is my first crank I have done myself, and I almost got it dead straight, 0.04mm woble at the end (were oil goes in).
Also new roller bearings for the crank, and new ball-bearing for the balance shaft.
Will also install a new stock Asso piston/sleeve.
Is it safe btw to use the cams from my other head? Those have been timed and have good auto-decomp.
I will have the bottom-end ready today. I have a early style H-beam crank wich is from a X440S wich has been ridden once, so the shaft and rod are perfect. I installed a Z400 bearing and pressed it together 15 minutes ago. This is my first crank I have done myself, and I almost got it dead straight, 0.04mm woble at the end (were oil goes in).
Also new roller bearings for the crank, and new ball-bearing for the balance shaft.
Will also install a new stock Asso piston/sleeve.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm