engine wont fire over
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Maybe the metal shavings are left over in the frame from a previous bearing failure?I have read posts about people using rare earth magnets to catch shavings.I think kdeal sells them,not sure though,goodluck with the re-build.Bty,maybe you should check into a bored throttle body since your head is ported.Are you running the stock airbox?
If you have a good port then having a port matched throttle body and intake is a must.
The higher compression piston isn't worth the money IMO. They will get you a little more hp but they are damned expensive. All depends on what you are looking for. Max hp then get one, just a strong motor then don't worry about it.
The higher compression piston isn't worth the money IMO. They will get you a little more hp but they are damned expensive. All depends on what you are looking for. Max hp then get one, just a strong motor then don't worry about it.
i flushed the entire frame before the last build, better believe i wanted everything out after buying a new crank!
that's what i figured. the port job seems to be pretty good, so yeah i will look into the TB. No stock air box here, got a setup i think from boomer, basically a K&N with a mud flap; screams when wide open. with the money i can save on the piston kit, looks like that kick *** trail tech kit is getting ordered.
that's what i figured. the port job seems to be pretty good, so yeah i will look into the TB. No stock air box here, got a setup i think from boomer, basically a K&N with a mud flap; screams when wide open. with the money i can save on the piston kit, looks like that kick *** trail tech kit is getting ordered.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm