anybody ever try different plastic on a dale
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE (SlOoT @ Nov 12 2009, 02:59 PM) <{POST_SNAPBACK}>
Received my plastic, will try it tomorrow
The seat on the new YFZ looks nice,very Suzuki like,hope it can be modded to fit.
Put it on today. It will be difficult to determine the excact position of the plastic due to the shape of the area around the fuel tank. The frame is a bit to wide there...
Stock fueltank will NEVER work, and I doubt stock subframe will work coz the rear plastic will be to high. I want it as low as possible.
Will make some pictures and upload them asap.
Stock fueltank will NEVER work, and I doubt stock subframe will work coz the rear plastic will be to high. I want it as low as possible.
Will make some pictures and upload them asap.
I now have the plastic in place. It can be mounted very low.
It does require a podfilter setup, I have a Canniboomer podfilter setup, fits very good. Stock airbox will be difficult I think.
A new ECU tray has to be made to move the ECU back against the steering stem.
It is possible to use stock ECU tray, but it will look like a hack job...
A new, lower, subframe has to be made, but that is easy.
The difficult part is the fuel tank. I think I will make it underneath the seat, with a tube from the stock tankhole going down.
The coolant reservoir can fit in stock location, but will be very tight. I think I will slightly relocate it.
It does require a podfilter setup, I have a Canniboomer podfilter setup, fits very good. Stock airbox will be difficult I think.
A new ECU tray has to be made to move the ECU back against the steering stem.
It is possible to use stock ECU tray, but it will look like a hack job...
A new, lower, subframe has to be made, but that is easy.
The difficult part is the fuel tank. I think I will make it underneath the seat, with a tube from the stock tankhole going down.
The coolant reservoir can fit in stock location, but will be very tight. I think I will slightly relocate it.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE (SlOoT @ Nov 13 2009, 05:00 AM) <{POST_SNAPBACK}>
The difficult part is the fuel tank. I think I will make it underneath the seat, with a tube from the stock tankhole going down.
This is what I had planned when my son was racing. I wanted to cut the tank size down and planned on useing a flexable hose from the tank to the filler cap so if I needed to change a plug quickly, all I would have to do would be remove the seat and gas cap then bend the hose out of the way.