wants to stall
I wondering if anyone can help me out? Just put a pod filter on myblaze took it out and it was to lean so I made it richer,but now when I start it to let it warm up it will run great for a few minutes then rpms will start to drop to the point where if I let it it will die. After it dies it takes for ever to get it started. any ideas would be great
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
2603 sounds like it may have still been at the factory setting with a choked down muffler (cannible/speed). do you have an aftermarket exhaust also and were the settings allready changed for that?
Just my thinking but figure the pods better air flow wouldn't affect as much at low rpms or idle and if your original setting was on the rich side maybe you took to big a swing at it with 2400. I would also wonder how you are determining it that it was to rich at 2400
weird but for referance my speed factory setting was 2603 and Moto was 2400
I guess I would also ask what else has been done to the engine and exhaust.
Just my thinking but figure the pods better air flow wouldn't affect as much at low rpms or idle and if your original setting was on the rich side maybe you took to big a swing at it with 2400. I would also wonder how you are determining it that it was to rich at 2400
weird but for referance my speed factory setting was 2603 and Moto was 2400
I guess I would also ask what else has been done to the engine and exhaust.
It has full HMF system on it.The motor itself is stock, when I ran it for a while then did a plug check the plug was black so I took a little fuel out of it. When I put the pod filter on I took it out for a ride did a plug check and the plug was completely white.So to set the idle speed do I not set it by the idle screw. Also I got rid of the quick connects.When I calibrated the throttle I disconnected the throttle cable an did by hand making sure it was closed completely and open all the way
Doing a throttle cal also requires turning the idle adjuster knob down so it no longer will touch the throttle cam. Then you hold the throttle closed and hit the low setting on the D@M screen. Running extreme lean will cause surging and choopy throttle response with possible backfiring out the tailpipe. Rich will just be boggy. Super rich at idle will usually require a lot of idle screw adjustment to get the idle to come up to where its supposed to be.