Anyone know who makes these?
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE (Brad77 @ Jan 16 2011, 08:49 PM) <{POST_SNAPBACK}>
+1
Yeah they def. look like American Star arms
Yeah they def. look like American Star arms
thats a good start, any way to tell sizing by measurements, also is going through them the best way to get the rebuild parts?
If I am not mistaken Boomer had a very reliable and long lasting sealed ball joint kit for these that wouild be the way to go in the long run.
The good thing about those joints is that they will run unbelievably sloppy without pulling out. The bad thing about them is running open like that tends to eat them up but you usually at least get your monies worth out of them when you buy them new. I have a set and only needed to replace the lowers and somebody had some tighter ones here for cheap.
The good thing about those joints is that they will run unbelievably sloppy without pulling out. The bad thing about them is running open like that tends to eat them up but you usually at least get your monies worth out of them when you buy them new. I have a set and only needed to replace the lowers and somebody had some tighter ones here for cheap.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm