I noticed some coolant had ran down the front of the motor the only place I could see that was wet was around the vent tube from the top of the water pump back to res tank. Anything to be worried about? I may have had it on the warm side while riding in the sand.
Look and make sure it did not come out the weep hole on the underside of the head directly under the water pump. (get on the ground and look up there above the water outlet in a recess). If not from there, most likely escaped from too much pressure, then it leaks around the cap of the ressy.
The only place that was wet was right where the self venting hose comes off the pipe barb on the water pump housing to the hose returning to the ressy. There was no leakage around the ressy tank cap or main line.
The factory used just a wire clamp that was installed and removed with just a pair of pliers on the ressy. On the water pump housing it should have came with a used once Oetiker clamp that is pinched on. Cannondale did have a factory bulletin changing the wire clamp to a regular worm clamp. Lesson learned, you still should look at the Cannondale factory bulletins for ideas as well as all the neat stuff we have done post-Cannondale.