cut fender pics
I don't have the pics yet...but
The rear edge was cut to where the fender meets the frame spar (sidepanel)
When taping, I started from the front and followed the contour line in the fender. Then, using a second bit of tape, I made my own line from the spar to the first line.
When happy with the taping, I put on my eye protection and picked up the Dremel.
Time taken:
Taping 1/2 hour
Cutting 1 minute
Finishing 15 minutes
Get yourself a roll of electrical tape and get out there and play.
The rear edge was cut to where the fender meets the frame spar (sidepanel)
When taping, I started from the front and followed the contour line in the fender. Then, using a second bit of tape, I made my own line from the spar to the first line.
When happy with the taping, I put on my eye protection and picked up the Dremel.
Time taken:
Taping 1/2 hour
Cutting 1 minute
Finishing 15 minutes
Get yourself a roll of electrical tape and get out there and play.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
i like them a lot, they are set up to the "moto" standards, so i dont quite reach 50" but they are very nice, strong, and great looking arms..www.diamondracingatv.com (Big Winky On here) give em a call he's a great guy and his stuff is awesome! ( not to mention cheaper than most other brands!):deal:
another view
another view
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
...
believe it or not i drew my lines with a marker and cut with a handheld jigsaw....i was scared at first but once u get goin its a breeze.