I have an '02 Blaze that runs rough and cuts off when I try to rev it up. It cranks fine and was running good but then, while ridding it, it started cutting out when I tried to rev it up. It acts like it is not getting enough fuel.
Any suggestions would be greatly appreciated.
won't rev., please help
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
GOT GAS?
I'd be checking a few things here...
Fuel filter (just replace it!)
Quick connect o-rings (check for cracks/splits. Grease lightly)
Fuel pick-up line (inside tank. Can get twisted in a crash)
Fuel lines (some were prone to "pinholing")
Just remember that anytime you are playing around the fuel pump that one careless short can fry the ECU....be warned! Oh, and fit a boot on the uncovered pump terminal if it isn't already fitted.
Good luck with these tips and get back to us.
I'd be checking a few things here...
Fuel filter (just replace it!)
Quick connect o-rings (check for cracks/splits. Grease lightly)
Fuel pick-up line (inside tank. Can get twisted in a crash)
Fuel lines (some were prone to "pinholing")
Just remember that anytime you are playing around the fuel pump that one careless short can fry the ECU....be warned! Oh, and fit a boot on the uncovered pump terminal if it isn't already fitted.
Good luck with these tips and get back to us.
Dude My quad did the same thing while I was driving along and hit the gas it just died and rolled almost to a stop and backfired and kept running. My fuel filter was ok but the pickup screen in the tank was plugged completely with the nastiest brown goo. It would idle perfectly and go slow but reving it up made it die. Its easy to get the strainer out ,it just unscrews. Hope this helps.