Cannibal isn't running.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Cannibal isn't running.
I tried starting my cannibal today after 2 weeks of sitting in my garage. I let it idle for a few seconds but then it died. I think it ran out of gas b/c it was low from the last time I rode it. So, I put gas in it and then tried to start it again. It started and idled for about 3-5 seconds then died. If I keep trying to start it after it idles and then dies, it starts backfiring a little. If I let it sit or take the spark plug out and clean it (also turning it over w/o the spark plug to clear the fuel from the cylinder), it will start again and idle for another 3-5 seconds. It repeats the process over and over. I'm thinking it is either a fouled plug or it is just running too rich. I don't have the D&M kit. I can't get a new plug until Monday morning to try that. Just looking for some opinions.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Could be a low battery, the battery will drain when the quad is just sitting idle and it will mess with the ECU. Try charging the battery and try it. The only way the battery will start to charge is when u rev the engine, otherwise just sitting idle runs pretty much everything off the battery and the battery doesn't
get anough voltage to charge up. ALso if you want to be sure, hook your car battery up to it, if it runs fine, then it's your battery.
get anough voltage to charge up. ALso if you want to be sure, hook your car battery up to it, if it runs fine, then it's your battery.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
A well chraged battery will give a reading of 12.6 or 12.8 volts. It doesn't matter how new the battery is, if its sitting in the cold it will discharge. It doesn't have to even be connected, cold weather discharges batterys. The only reason cars dont have this problem as much is because the batterys are alot bigger.
^^Sounds fair to me^^
I'd just like to add 2 more things:
#1 You should also check that all the connections are tight (including the ground to the frame)
#2 Check to see that your battery is not being damaged by rubbing on the engine case. If you find it is, you need to loosen/remove the battery tray and put some extra washers under the rear.
OH, and throw a new plug in "just in case".
I'd just like to add 2 more things:
#1 You should also check that all the connections are tight (including the ground to the frame)
#2 Check to see that your battery is not being damaged by rubbing on the engine case. If you find it is, you need to loosen/remove the battery tray and put some extra washers under the rear.
OH, and throw a new plug in "just in case".
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm