center of graavity
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Also on the Cannibal, Speed and Blaze, check the travel of your A-Arms. Take your shocks off and see if the a-arms move freely. 9 times out of 10, they'll be sticky. Remove the a-arm bolts, clean out the bolt holes, clean the bolts up, grease the bolts pretty good, apply some blue loctite(the removeable type) to the nut, and tighten the bolts right to the point where the arm starts to bind up. Just make sure before each ride/race to check the nuts and make sure they won't fall out. I use to have the same problem until I started doing this. And also if you have the 21" holeshot fronts, replace those with a good 4 ply tire. The Holeshots are only 2 ply and tend to roll easy in the turns.
Hope this helps!
Hope this helps!