A-Arm Installation
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
A-Arm Installation
Can anyone offer some input on the best way to install new camber/caster adjustable A-Arms? Mine arrived today and I know from my past experience that I got really frustrated trying to get everything aligned just right.
Is the best way to screw the upper and lowers in all the way and then back one or the other out? Or is their some kind of science to it?
And is there any special I should know about on the Cdale that would suck to find out later?
Is the best way to screw the upper and lowers in all the way and then back one or the other out? Or is their some kind of science to it?
And is there any special I should know about on the Cdale that would suck to find out later?
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE
Originally posted by Jaybr
It's pretty straitforward, nothing particullarly difficult about the Dale arms other than getting the ball joints out.
I always screw everything in all the way and then adjust from there.
It's pretty straitforward, nothing particullarly difficult about the Dale arms other than getting the ball joints out.
I always screw everything in all the way and then adjust from there.
After you put the spindals back on how do you adjust the joints? Do you remove the ball from the socket? Or turn the arm until it's where you need it?
QUOTE
Originally posted by TheJaspMan
After you put the spindals back on how do you adjust the joints? Do you remove the ball from the socket? Or turn the arm until it's where you need it?
After you put the spindals back on how do you adjust the joints? Do you remove the ball from the socket? Or turn the arm until it's where you need it?
If you leave everything loose, the ball joint will pop right out of the spindle for adjustment. After the ball joint is seated tight in the spindle, I think it's easier to remove the frame side and spin it.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm