Fuel pump shot?
Fuel pump shot?
My fuel pump seems to still be leaking. I turn the bike on, push the start button, then hear a pop the bike is not turning over and when I look down, gas is coming out of the fuel pump at a good rate. I have tightened the bolt to the fuel out line and now I am just stumped. I don't know if I have fried something when I put the motor back in. BUT I have had it running since I put it back in. Any suggestions would be great. I will try to take pictures if possible.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Cannondale part #5001501 is a fuelpump banjo fitting, but don't know if it has the aluminum disc washers. Better to try an industrial fastener supply, as they should have 'em. Be sure to not short across the fuel pump terminals, since always hot and easy to fry the ECU -- everyone says to disconnect first or disconnect battery....worst case scenario would be thin layer permatex to existing washers. Good luck
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm